Z AUTOMOTIVE BURNBOX G1 (2005-2009 Chrysler 300, 2006-2009 Dodge Charger & 2008-2014 Challenger)

Line Lock: Using one of the cruise control buttons/lever (depending on vehicle model), the BurnBox G1 uses the ABS valves to hold the vehicle with the front brakes so you can hit the gas and do a perfect burnout as long as you wish, with no wear on the rear brakes. No plumbing is required! This is a perfect alternative to the traditional plumbed-in solenoid type line lock/roll control. Super simple and cannot be detected! Gone are the days of plumbing in external solenoids in the brake system, having to bleed the brakes and run wires through the firewall to a switch.

Light Show: Using steering wheel buttons, turn on a light show that flashes the exterior lights in 6 different patterns.

- 6 pre-set patterns

Z Automotive Programming Utility (for Windows PCs only) is used for firmware updates and for configuration:

- Choose which exterior lights are included in the patterns
- Choose which pattern to start with
- Can be enabled for in-motion use for authorized users and off-road parade use; email tech support for instructions

Cooldown: Turn on the engine fan, (2 speeds) for cooling down the vehicle between runs at the track. Low battery automatic shutdown.

INSTALLATION IS A SIMPLE MATTER OF PLUGGING IT INTO THE DIAGNOSTIC OBD2 PORT WHICH IS LOCATED ABOVE THE PARKING BRAKE.

*needs to be unplugged when vehicle is parked overnight

Works with Dodger Charger / Chrysler 300/ Dodge Magnum 2005 -2010
Works with Dodge Challenger from 2008- 2014